Результаты поиска

Суть проблемы: если настроить LVM поверх /dev/loopX устройств то после перезагрузки приходится делать losetup вручную. Соответственно не работают сервисы

10-desktop-i386.iso" loopback loop (hd0,1)$isofile linux (loop)/casper/vmlinuz boot=casper iso-scan/filename=$isofile nomodeset initrd (loop)/casper/initrd.lz else

один физический порт. ZXAN(config-if)#show lacp internal Smartgroup:1 Flag *–LOOP is TRUE Actor Agg LACPDUs Port Oper Port RX Mux Port State Interval Priority

on the sending system so that the recipient device knows where the frame originated. Every Ethernet device, whether it’s installed in a server, a switch

предустановленными и настроенными ВМ Скачать ESXi ISO Подмонтировать образ: mount -o loop VMware-VMvisor-Installer-5.x.x-XXXXXX.x86_64.iso /esxi_cdrom_mount Cкопировать

раздел: %# mount -o loop,offset=213889536 /xen/images/vm1.img /mnt %# mount -snip- /xen/images/vm1.img on /mnt type ext3 (rw,loop=/dev/loop0,offset=213889536)

@CurrentTableName FETCH NEXT FROM result_cursor INTO @CurrentTableName END --end loop --clean up CLOSE result_cursor DEALLOCATE result_cursor --UPDATE #TableList

CentOS-5.8_i386_PayPalLinux_09___VM_09 --storagectl "IDE Controller" --port 0 --device 0 --type hdd --medium /home/mmaxur/virtual/CentOS-5.8_i386_PayPalLinux_09___VM_09

Escape character is '^]'. *********************************************** ** Device Model  : IGD ** ** Mac Address  : 00:08:3C:06:05:94 ** ** Soft Version  :

devices on another faster device, so you will be able to get the better access performance. The ulobdev tool is for a generic block device, and the ulohttp is

objCoreInit-2 objCoreInit-1, pObjCore:0xcb71700, pObjClass:0xcb715a8 objCoreInit-2 Device / was created // - disk check in progress ... // - Volume is OK total #