Ceph2: различия между версиями

Материал из noname.com.ua
Перейти к навигацииПерейти к поиску
Строка 23: Строка 23:
 
</PRE>
 
</PRE>
   
==Remove the <code>OSD</code> from the Ceph cluster==
+
==Удалить <code>OSD</code> из кластера Ceph==
 
<PRE>
 
<PRE>
 
ceph osd rm osd.123
 
ceph osd rm osd.123
 
</PRE>
 
</PRE>
Please keep in mind that whenever an OSD is unavailable your cluster health will not be OK, and it will continue to perform the recovery which is a normal Ceph operation in this situation.
+
Please keep in mind that whenever an OSD is unavailable your cluster health will not be OK,
  +
and it will continue to perform the recovery which is a normal Ceph operation in this situation.
5. So as long as the server is hot swappable which it should be, then just put the new drive in and perform the following tasks. If its node-2 then, keep in mind you will need to use the name of your node.
 
  +
==Заменить диск==
  +
Список дисков (после замены) посмотреть так:
 
<PRE>
 
<PRE>
 
ceph-deploy disk list node-2
 
ceph-deploy disk list node-2

Версия 13:38, 22 октября 2024

Ceph2

Сборник рецептов по ceph

Удаление OSD из кластера

  • 123 - номер OSD на удаление
  • node-2 - хостнейм ноды на котрой этот OSD
  • sdd - блочное устройство

Пометить OSD out из кластера Ceph

ceph osd out osd.123

Удалить сбойную OSD из CRUSH map

ceph osd crush rm osd.123

Удалить ключи (authentication keys) для OSD

ceph auth del osd.123

Удалить OSD из кластера Ceph

ceph osd rm osd.123

Please keep in mind that whenever an OSD is unavailable your cluster health will not be OK, and it will continue to perform the recovery which is a normal Ceph operation in this situation.

Заменить диск

Список дисков (после замены) посмотреть так:

ceph-deploy disk list node-2

Before adding the disk to the Ceph cluster, perform a disk zap

(Watch the output of the disk list for the location that gets assigned, that will be the location that you will run the osd create command on. For example if disk list output is [node-2][DEBUG ] /dev/sdd other, btrfs then disk zap will be the following:

ceph-deploy disk zap node-2:sdd

Create an OSD on the disk, and Ceph will add it as osd.123

ceph-deploy --overwrite-conf osd create node-2:sdd

Additional Information

Once an OSD is created Ceph will run a recovery operation and start moving placement groups from secondary OSDs to the new OSD. Again the recovery operation will take a while depending on the size of your cluster, once it is completed your Ceph cluster will be HEALTH_OK.

When a new host or disk is added to a Ceph cluster, CRUSH starts a rebalancing operation, under which it moves the data from existing hosts/disks to a new host/ disk. Rebalancing is performed to keep all disks equally utilized, which improves the cluster performance and keeps it healthy. Internal Notes