AP3602I

Как отконвертить точку для работы в stand-alone режиме без контроллера

• отключить питание
• зажать mode
• держать пока точка на консоль ненапишет что увидела нажатие
• enable
• debug capwap console cli
• debug capwap client no-reload
• capwap ap ip address 10.0.0.2 255.255.255.0
• capwap ap ip default-gateway 10.0.0.1
• archive download-sw /force /overwrite tftp://10.0.0.1/filename.tar

14. Once the upload, extraction, and installation is complete (3 to 5 minutes) the AP will restart. 15. Once the restart is completed log in and do a show version command. 16. Verify the AP now provides access to the full suite of IOS commands. 17. Configure as needed.

то же самое из rommon

Requirements:
1.TFTPd64 Server
2.Cisco IOS Software AP3G2-K9W7-M for (C3600 Series AP)
3.The Cisco AP and the Laptop with TFTP server must be in same network.

According to my network setup
Lightweight AP BVI1 IP address is 192.168.1.4
Laptop's IP address where TFTP server is installed 192.168.1.7 [Default Router IP]

First disconnect the ethernet cable from the AP then Press the Mode button and Put back the ethernet cable to the AP and hold the Mode button Untill flash light turns to umber and Once the Lightweight AP goes to online then apply the following commands to convert it to Autonomous version:

set IP_ADDR 192.168.1.4 [According to my network setup]
set NETMASK 255.255.255.0 [According to my network setup]
set DEFAULT_ROUTER 192.168.1.7 [According to my network setup]
tftp_init
ether_init
flash_init
tar -xtract tftp://192.168.1.7/ap3g2-k9w7-tar.153-3.JH.tar flash:
dir flash
set boot flash:/ap3g2-k9w7-mx.153-3.JH/ap3g2-k9w7-mx.153-3.JH
set
boot